Pentair COLOR SYNC CONTROLLER User Manual

Color Sync Controller Installation Guide
Color Sync Controller Installation Guide
16
17
PROBLEM/
FAULT
SYMPTOM CHECK SOLUTION
Lightsdonot
turn on.
Noneofthepool/
spa lights are on
after turning the
Controller on.
Be sure the wiring and
installation setup is
correct,andlinevolt-
age input (Black and
white) to the
Controller,and
switched output (Red)
wireisat120VAC.
If the Controller has an
LEDindicatorONlightON
nexttoacolororacolor
sequence,andvoltages
readcorrectlyat120VAC,
and Controller did not go
intooverloadcondition,then
replace the
Controller.
Lightsturn
ON but do not
remain
synchronized.
One or some of
the lights display
a different color
and do not stay in
sync with the rest
of the lights.
Check the Controller
and lights by
selecting one of the
xedcolormodes.
Resetthelight(s):Holdthe
Controller button until it
resets. Try again and see if
lights remain in sync. If not
replace the Controller.
Lightswillnotturn
on and all Color
SyncLEDsareall
ashing.
The Color Sync
controller has detected
an electrical load in
excessofthe
maximumallowable
wattageormaximum
allowable unit
temperature. Turn off
power at the circuit
breaker and inspect all
electrical systems
including Color Sync
transformer (if present).
Refertomaximum
wattage of light
controller (page 11) to
ensure power does not
exceed300W.
Reduce lights load (watt-
age)onthecontrollerand/
or replace damaged
electrical systems. Turn
OFF power to the controller
offatthecircuitbreaker,
thenturnbackontore-set
the controller to resume
operation.
Troubleshooting the Color Sync™ Controller
Use the following troubleshooting chart to resolve some of the common faults
or problems.

Pentair COLOR SYNC CONTROLLER Specifications

General

Brand	Pentair
Model	COLOR SYNC CONTROLLER
Category	Controller
Language	English