Pentair COLOR SYNC CONTROLLER User Manual

Color Sync Controller Installation Guide
Color Sync Controller Installation Guide
14
15
To remove and install a new gasket:
1. Remove the two front screws from the front plate.
2. Carefully remove the controller, face plate and gasket from the outlet
box.
3. Using a small flat-blade screw drive, disconnect the three (3) power
wires by loosen the three (3) screws on the connector terminals located
on the lower rear side of the controller. See page 12 for wiring diagram.
4. Separate the gasket from the face plate and discard the gasket.
TURN power OFF at circuit breaker - Always disconnect power to
the pool light at the circuit breaker before servicing the light. Failure
to do so could result in death or serious injury to installer, service
person, pool users, or others due to electrical shock.
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
Controller and Gasket
Front screw (x2)
Gasket
3 wire connector
screw terminal
COLOR SYNC CONTROLLER MOUNTING KIT REPLACEMENT
MOUNTING KIT CONTENTS (P/N 602159Z):
•
Gasket, Screws (x2), Grease Packet

Pentair COLOR SYNC CONTROLLER Specifications

General

Brand	Pentair
Model	COLOR SYNC CONTROLLER
Category	Controller
Language	English