Pentair INTELLIFLO VSD 2 Series User Manual

P-QSG-VSD2 - Rev. September 2017
9
INTELLIFLO VSD 2 - QUICK START GUIDE
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
ENGLISH
ESPAGNÕL
PUMP OPERATIN MODES
The IntelliFlo
®
VSD 2 Variable Speed Pump can be programmed in three different modes:
Speeds 1-4 can be programmed in all three modes. Speeds 5-8 can only be programmed in Schedule mode since
there are no buttons on the control panel for Speeds 5-8. The default setting for Speeds 5-8 is “Disabled”.
Manual
Assigns a speed to one of the four speed buttons on the control panel. This mode can only be used for speeds 1-4.
Speeds 1 and 2 are manual by default. To operate in manual mode, press one of the four speed buttons and then
press the Start/Stop button. The pump will run the assigned speed for that speed button.
Egg Timer
Speeds 1-4 can be programmed to run at a certain speed and for a duration of time once pressed. Speeds 3 and
4 are Egg Timers by default. This prevents the pump from running at a speed higher than half of the maximum
speed indefinitely. If you desire a different method of operation, speeds 3 and 4 can be changed to manual mode
in the control menu.
To operate in Egg Timer mode, press a speed button and then press Start/Stop. The pump will run that speed for
the set amount of time and then turn off.
Schedule
Program speeds 1-8 start and stop at a specific time during a 24 hour period. Speeds programmed in schedule
mode will override any manually selected speed once the next schedule command starts.
Speed 1 (1-4)
Manual
Schedule
Egg Timer
Set Speed - Default: MANUAL
Set Speed
Set Start Time
Set Stop Time
Set Speed
Time
Speed 5 (5-8)
Schedule
Set Speed
Set Start Time
Set Stop Time
Disabled
Default: Disabled
Program Menu Tree Options

Pentair INTELLIFLO VSD 2 Series Specifications

General

Brand	Pentair
Model	INTELLIFLO VSD 2 Series
Category	Water Pump
Language	English