Perlick H80CIMS-AD User Manual

PERLICK RESIDENTIAL UNDERCOUNTER CUBELET ICE MAKER PRODUCT MANUAL
perlick customer service (800)558-5592 | 21
ELECTRICAL CONNECTION
Electrical connecon must meet naonal,
state, and local electrical code requirements. Failure to meet
these code requirements could result in death, electric shock,
serious injury, re, or damage.
The appliance requires an independent
power supply of proper capacity. See the nameplate for
electrical specicaons. Failure to use an independent power
supply of proper capacity can result in a tripped breaker,
blown fuse, damage to exisng wiring, or component failure.
This could lead to heat generaon or re.
THE APPLIANCE MUST BE GROUNDED:
The appliance is equipped with a NEMA 5-15 three-prong
grounding plug to reduce the risk of potenal shock hazards.
It must be plugged into a properly grounded, independent
3-prong wall outlet. If the outlet is a 2-prong outlet, it is your
personal responsibility to have a qualied electrician replace
it with a properly grounded, independent 3-prong wall outlet.
Do not remove the ground prong from the power cord and
do not use an adapter plug. Failure to properly ground the
appliance could result in death or serious injury.
Do not use an extension cord.
To reduce the risk of electric shock, do not
touch the control switch or plug with damp hands. Make sure
the control switch is in the “OFF” posion before plugging in
or unplugging the appliance.
Do not use an appliance with a damaged
power cord. The power cord should not be altered, jerked,
bundled, weighed down, pinched, or tangled. Such acons
could result in electric shock or re. To unplug the appliance,
be sure to pull the plug, not the cord, and do not jerk the
cord.
The GREEN ground wire in the factory-
installed power cord is connected to the appliance. If it
becomes necessary to remove or replace the power cord, be
sure to connect the power cord’s ground wire to this screw
upon reaachment.
Usually an electrical permit and services of a licensed
electrician are required.
The maximum allowable voltage variaon is ±10 percent of the
nameplate rang.
For oponal drain pump (63802A) installaon, refer to the
instrucons included with the pump.
DANGER
!
DANGER
!
DANGER
!
DANGER
!
DANGER
!
DANGER
!
DANGER
!

Perlick H80CIMS-AD Specifications

General

Brand	Perlick
Model	H80CIMS-AD
Category	Ice Maker
Language	English