Perlick H80CIMS-AD User Manual

PERLICK RESIDENTIAL UNDERCOUNTER CUBELET ICE MAKER PRODUCT MANUAL
perlick customer service (800)558-5592 | 25
STARTUP
STARTUP
All parts are factory-adjusted. Improper
adjustments may adversely aect safety, performance,
component life, and warranty coverage.
If the appliance is turned o, wait for at least
3 minutes before restarng the appliance to prevent damage to
the compressor.
At startup, conrm that all internal and
external connecons are free of leaks.
1. Open the water supply line shut-o valve.
2. Make sure the control switch is in the “OFF” posion. Plug
the appliance into the electrical outlet.
To reduce the risk of electric shock, do not
touch the control switch or plug with damp hands. If you
have to slide the appliance back for a built-in installaon,
make sure you do not damage or pinch the water supply line,
drain line, or power cord.
3. If required by sanitaon code in your area, seal the
perimeter where the appliance touches the oor with
approved caulk compound in a smooth and easily cleanable
manner.
4. Move the control switch to the “ICE” posion to start the
automac icemaking process.
5. Once the appliance starts to produce ice, allow it to run for
another 30 minutes.
6. Move the control switch to the “OFF” posion.
7. Remove the ice produced, then clean the storage bin liner,
door liner, and door gasket using a neutral cleaner. Rinse
thoroughly aer cleaning.
8. Move the control switch to the “ICE” posion to start the
automac icemaking process.
9. To conrm bin control operaon, hold ice in contact with
the bin control thermostat bulb. If the icemaker does not
stop within 10 seconds, the bin control thermostat must be
adjusted. Installaons at higher altude locaons are more
likely to require adjustment.
DANGER
!
WARNING
WARNING
DANGER
!

Perlick H80CIMS-AD Specifications

General

Brand	Perlick
Model	H80CIMS-AD
Category	Ice Maker
Language	English