8
Standard Presser Foot 0
This foot is used mainly for straight stitching and zigzag stitching
with a stitch length longer than 1.0 mm.
Clearview Foot 1
When sewing decorative stitches or short zigzag stitches and
other utility stitches with less than 1.0mm stitch length, use this
IRRW7KHJURRYHRQWKHXQGHUVLGHRIWKHIRRWLVGHVLJQHGWRÁRZ
smoothly over the stitches.
Four-Step Buttonhole Foot 5A (for 130s/140s)
6OLGLQJSODWHXQGHUIRRWKDVFRQYHQLHQWO\VSDFHGPDUNLQJVWRVWDUW
and stop your buttonhole at precisely the correct point.
Blindhem Foot 3
This foot is used for blindhem stitches. The toe on the foot guides
the fabric. The red guide on the foot is designed to ride along the
fold of the hem edge.
Note: Always use at least 5mm stitch width when using Blind Hem Foot
3. If using a stitch width other than the recommended, swing the needle
by turning the hand wheel to make sure the needle doesn’t hit the metal
pin in the foot.
One-Step Buttonhole Foot 5B (for 150s/160s)
This foot has a space in the back for a button used to set the size of
WKHEXWWRQKROH7KHPDFKLQHZLOOVHZDEXWWRQKROHWRÀWWKDWEXW-
ton size.
Zipper Foot 4
This foot can be snapped on either the right or the left of the nee-
dle, making it easy to sew close to both sides of the zipper teeth.
Move the needle position to the right or left to sew closer to zipper
teeth.
Presser Feet
To Next Page
Loading...
Need help?
General
