Mechanical Instructions
EN 18 QFU1.2E LA4.
2014-Jan-10
back to
div. table
Figure 4-15 Cable dressing 84" 9000 series - Back cover
4.2 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display.
Caution: Failure to follow these guidelines can seriously
damage the display!
Ensure that ESD safe measures are taken.
4.3 Assy/Panel Removal
4.3.1 Rear Cover
Warning: Disconnect the mains power cord before removing
the rear cover.
Attention: For Ambilight sets, the leading edge cover has to be
removed.
It is mandatory to remove the leading edge cover and
disconnect the cables prior to removal of the rear cover!
See Figure 4-16
and Figure 4-17 for details.
1. For sets equipped with Ambilight: remove the stand and
swivel block [1].
2. Remove the leading edge hatch that covers the Ambilight
connector [2].
3. Unplug the Ambilight connectors located underneath the
hatch [3].
4. Lift the rear cover from the TV. Make sure that wires and
flat foils are not damaged while lifting the rear cover from
the set.
Figure 4-16 Rear cover removal Ambilight models -1-
To Next Page
Loading...
Need help?
General