off Ultra HD for this HDMI connection.
If the picture and sound of a device connected with
HDMI is distorted, check if a different HDMI Ultra
HD setting can solve this problem. In Help > User
manual, press the colour key Keywords and
look up HDMI Ultra HD.
• If there are intermittent sound disruptions, make
sure that output settings from the HDMI device are
correct.
HDMI EasyLink does not work
• Check if your HDMI devices are HDMI-CEC
compatible. EasyLink features only work with devices
that are HDMI-CEC compatible.
HDMI eARC is not working well
• Make sure the HDMI cable is connected to HDMI 1.
• Make sure the Ultra High-speed HDMI cable is
used for eARC connection.
• Only one eARC device is available at a time.
No volume icon shown
• When an HDMI-CEC audio device is connected and
you use the TV Remote Control to adjust the volume
level from the device, this behaviour is normal.
24.9
USB
Photos, videos and music from a USB device do not
show
• Check if the USB storage device is set to Mass
Storage Class compliant, as described in the storage
device's documentation.
• Check if the USB storage device is compatible with
the TV.
• Check if the audio and picture file formats are
supported by the TV. For more information, in Help,
press the colour key Keywords and look
up Multimedia.
Choppy playback of USB files
• The transfer performance of the USB storage device
may limit the data transfer rate to the TV which
causes poor playback.
24.10
Wi-Fi and Internet
Wi-Fi network not found or distorted
• Check if the firewalls in your network allow access
to the TV's wireless connection.
• If the wireless network does not work properly in
your home, try the wired network installation.
Internet does not work
• If the connection to the router is OK, check the
router connection to the Internet.
The PC and Internet connection are slow
• Look in your wireless router's user manual for
information on indoor range, transfer rate and other
factors of signal quality.
• Use a high-speed (broadband) Internet connection
for your router.
DHCP
• If the connection fails, you can check the DHCP
(Dynamic Host Configuration Protocol) setting of the
router. DHCP should be switched on.
24.11
Wrong Menu Language
Change the language back to your language
1 - Press Home and select Settings via the icon at
the top right corner.
2 - Press 7 times (down) and press OK.
3 - Press OK again to enter Language, select the first
item Menu language and press OK.
4 - Select your language and press OK.
59
To Next Page
Loading...
Need help?
General