1. Installation and usage
- This device can only attach to faucets with a diameter between 15mm and 24mm.
- Before attaching the device on the faucet, the matching adaptor should be selected first.
- The adaptors allow this device to be attached to most faucets, except for:
· faucets with a diameter of less than 15mm or more than 24mm
· faucets with a shower head
· faucets with rectangular or oval shaped outlets
· faucets with a sensor head
Installation
Preparation
Based on different adaptors, please refer to different installation method.
Installing A-type adaptors
Applicable for faucet aerators with male thread
(1) Remove the original aerator cap and seal ring from the tap.
(2) Screw the matching adaptor (A-type) onto the faucet.
(3) Use mini wrench to tighten the adaptor.
Installing B-type adaptors
Applicable for faucet aerators with female thread
(1) Remove the original aerator cap from the tap.
(2) Take out the original adaptor and screw the matching adaptor (B-type) onto the tap.
(3) Use mini wrench to tighten the adaptor.
EN 1
B1-1
B1-2
A1-1
A1-1 A1-2
A1-2
To Next Page
Loading...
Need help?
General
