Philips DCM129/12 - Troubleshooting

12 EN
Search Selectivity >28 dBf
Total Harmonic
Distortion
<3%
Signal to Noise Ratio >55 dB
Speakers
Speaker Impedance 4 ohm
Speaker Driver 3.5" full range
Sensitivity >82 dB/m/W
General information
AC power 220-240 V~, 50/60 Hz
Operation Power
Consumption
14 W
Standby Power
Consumption
<0.5 W
iPod/iPhone charge 5 V, 1A
Dimensions
- Main Unit
(W x H x D)
- Speaker Box
(W x H x D)
152 x 174 x 236 mm
132 x 175 x 158 mm
Weight
- Main Unit
- Speaker Box
1.1 kg
2 x 0.9 kg
9 Troubleshooting
Warning
•
Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requestingservice.Iftheproblemremains
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
• Ensure that the AC power cord of the unit
is connected properly.
• Ensure that there is power at the AC
outlet.
• As a power-saving feature, the system
switches off automatically 15 minutes after
track play reaches the end and no control
is operated.
No response from the unit
• Disconnect and reconnect the AC power
plug, and then turn on the system again.
No sound or poor sound
• Adjust the volume.
• Check if the speakers are connected
correctly.
• Check if the stripped speaker wires are
clamped.
Remote control does not work
• Beforeyoupressanyfunctionbutton,rst
select the correct source with the remote
control instead of the main unit.
• Reduce the distance between the remote
control and the unit.
• Insert the battery with its polarities (+/–
signs) aligned as indicated.
• Replace the battery.