18 Front Panel
Remote sensor
This sensor receives the commands from the DVD
Player’s remote control.When using the Player’s remote
to operate the Player, point the remote here (not
toward your TV).
PAUSE 8 button
Press during playback to pause play; press again to
resume play from the same point.
PLAY 3 button
Press to start playing a Disc.
STOP 7 button
Press once to stop Disc playback. Play will resume from
the same point the next time you start playback. Details
are on page 16.
Or press STOP 7 twice to stop Disc playback. Play will
resume from the beginning of the Disc the next time
you start playback.
You must stop playback by pressing STOP 7 twice in
order to access PREFERENCE SETUP in the DVD
Player’s Setup menu.
OPEN/CLOSE / button
Press to open or close the Disc tray.
STANDBY-ON
yy
Button
Press to turn the DVD
Player on or off (Standby).A
red light will appear on the
front of the Player when the
power is off (Standby).
Disc Tray
Insert a Disc here. Load the
Disc with the label facing up
and the shiny side facing
down. If the Disc is two-
sided, place the Disc in the
tray with the label of the
side you want to play facing
up. Details are on page 16.
Display Panel
Current Disc details appear
here, including the elapsed
playing time of a Disc. SEARCH,
PAUSE, HOLD (play is stopped),
MUTE (ON or OFF), OPEN,
CLOSE, LOAD, OFF (power is
turning off), MENU, or Repeat
messages also appear here to
indicate the current status of
the Player or Discs.
To adjust the brightness of the
display panel, set DISPLAY DIM.
Details are on page 39.
To Next Page
Loading...
Need help?
General
