Philips NORELCO BT5210 User Manual

-
If you are trimming for the first time,
start by using the guard at the
maximum trimming length setting
(23/32in, 18mm) to prevent
accidentally trimming hairs too short.
As you become familiar with the
settings, turn the zoom wheel to set to
desired trimming length. The zoom
wheel will click into position at each
setting.
4 Switch on the product.
5 To trim most effectively, stretch the skin
with your free hand and move the
product against the hair growth direction
(Fig. 16). Make sure that the surface of
the guard always stays in contact with
the skin.
Note: Since hairs do not all grow in the
same direction, you may want to try
different trimming positions (i.e. upwards,
downwards, or across). Practice is best
for optimum results.
-
When you use the appliance on your
armpits, raise your arm and put your
hand on the back of your head to
stretch the skin.
-
If cut hairs have accumulated in the
guard during use, switch off the
product, remove the guard and blow
and/or shake the hair out of the
guard.
6 Switch off and clean the product after
each use (see 'Cleaning').
Hair clipping
-
For best results, use the product on
clean, dry hair. Do not use it on freshly
washed hair.
-
Before you start clipping, comb the hair
in the direction of hair growth.
-
When you clip hair for the first time, strt
at the highest length setting to familiarize
yourself with the product.
-
To achieve optimal clipping results,
always move the product slowly through
the hair against the direction of hair
growth.
1 Make sure the product is turned off.
2 Slide one of the hair guards into the
guiding grooves on both sides of the
product (click) (Fig. 17).
3 Turn the zoom wheel to select the
desired length setting. The length setting
selected is shown on the front of the
product.
-
Short hair guard: select a length from
the red indications at the top, ranging
from 1/64in to 9/32in (0.4mm to
7mm) (Fig. 18).
-
Long hair guard: select a length from
the silver indications at the top,
ranging from 9/32in to 1/2in (7mm to
13mm) (Fig. 19).
4 Switch on the product.
5 Move the product slowly through the
hair, making sure that the surface of the
guard stays in contact with the skin (Fig.
20).
-
If cut hairs have accumulated in the
guard during use, switch off the
product, remove the guard and blow
and/or shake the hair out of the
guard.
6 Switch off and clean the product after
each use (see 'Cleaning').
Tip: Write down the settings you have used
to create a certain hairstyle as a reminder
for future clipping sessions.
Cleaning
Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive
liquids such as gasoline or acetone to
clean the product.
Clean the product and attachments after
each use.
1 Switch off the product and disconnect it
from the power outlet.
2 Wipe the handle of the product with a
dry cloth.
3 Remove the guard and clean it with the
cleaning brush and/or rinse it under the
tap (Fig. 21).
4 Clean the trimming head with the
cleaning brush and/or rinse it under the
tap (Fig. 22).

Philips NORELCO BT5210 Specifications

General

Brand	Philips
Model	NORELCO BT5210
Category	Electric Shaver
Language	English