3 Get started
Charge the battery
Before you use your headphones for the rst
time, charge the battery for 2 hours for
optimum battery capacity and lifetime.
Use only the original USB charging cable to
avoid any damage.
Finish your call before charging the
headphones, as connecting the headphones
for charging will power the headphones o.
Connect the supplied USB charging
cable to:
• The USB type C charging slot on the
headphones and;
• The charger/USB port of a
computer.
Normally, a full charge takes 2 hours.
Pair the headphones with
your mobile phone
Make sure that the headphones are
fully charged and turned o.
Make sure that the mobile phone is
turned on and its Bluetooth feature
is activated.
The headphones remain in
pairing mode for 5 minutes
LED turns white during charging and
turns o when the headphones in
fully charged.
Press and hold for 5 seconds
until the blue and white LED ashes
alternately
Pair the headphones with the
mobile phone. For detailed infor-
mation, refer to the user manual of
your mobile phone.
Activate the Bluetooth feature
of your mobile phone, select
Philips TAH8506
1
2
3
4
Philips TAH8506
The following example shows you how
to pair the headphones with your
mobile phone.
Before you use the headphones with
your mobile phone for the rst time,
pair it with a mobile phone. A successful
pairing establishes a unique encrypted
link between the headphones and
mobile phone. The headphones store
the last 4 devices in the memory. If you
try to pair more than 4 devices, the
earliest paired device is replaced by the
new one.