NOhW that you have looked up
e three-digit Remote Code
Number for your brand of device,
you are ready to follow the/our
simple steps below.
Please read through steps 1-4
before beginning.
_ Place the TV/VCR/ACC
I Mode Switch in the proper posi-tion.
<_ Press the VCR RECORD
button on the remote control and
release.
<_ Press the SmartSound button
I on the remote within _0 seconds,
then release.
_@ Enter the THREE-DIGIT
REMOTE CODE NUMBER
for your desired device. The
remote is now ready to send
commands to the unit.
<_ Point the remote the
at
Device. Press the POWER button
on the remote to turn the unit
ON.
I
VCR
Satellite Receiver
or DBS, etc.
Cable Converter
SWAP SOURCE POSITION FREEZE
0000
_P _
0
Remember, if this doesn't
i work the first time, repeat steps
using the same remote code number.
After a second try and the remote
does not operate your device, see if
there is another three-digit code num-
ber (pages 34-35) listed for your
device and repeat the steps above
using thenew number.
If after repeated attempts the code
number method does not work you
device, try the SEARCH METHOD
on page 33.
J
52
To Next Page
Loading...
Need help?
General
