Swimming pool heat pump
- 22 -
14. Electrical Wiring
Before wiring, confirm the rated voltage of the unit as shown on its nameplate, then
carry out the wiring closely following the wiring diagram;
It is not allowed to change the wire connection of the unit by user; wire connection
must be made by qualified electrician; make sure the earthing is well， any change on
the way of earthing is not allowed.
Each wiring connection must be done in accordance with system diagram. Wrong
wiring may cause unit to misoperate or become damaged.
Do not allow wiring to touch the refrigerant tubing, compressor, or any moving parts of
the fan. Unauthorized changes in the internal wiring can be very dangerous. The
manufacturers will accept no responsibility for any damage or misoperation that
occurs as a result of such unauthorized changes.
Regulations on wire diameters differ from locality. For filed wiring rules, please refer
to your local electrical codes before beginning. You must insure that installation
complies with all relevant rules and regulation.
Please make the electrical connection according to the instructions below;
Notes: Please connect wiring to power switch at the final step to protect personal safety.
To Next Page
Loading...
Need help?
General
