Upon refitting, lubricate the bearings with the recommended grease.
- Roller bearings: use new casings at each refitting: observe the following rules: Wash the new case
with pure petrol or neutral petroleum to eliminate the rust preventer; after having applied the grease, fit
them with the face where the initials are marked facing outward. For their positioning, operate as indi-
cated in the respective figures of this chapter, using the specific equipment.
- Shafts and axles: sliding and rolling surfaces must not show notches and abrasions such as to impair
the proper operation and must be properly lubricated.
- Clutch: check the wear of the disks, the efficiency of the spring and all the components included in
the clutch assembly; if necessary replace damaged components.
- Gears: inspect the wear conditions of the teeth, if they are chipped or badly worn replace them with
new components.
- Front wheel axle chamfered nut.: at every reassembly a new nut must be applied, to be chamfered
on the corresponding shaft according to the instructions given in specific section "Locking the front
wheel brake drum."
- Always use new gaskets, split pins and brake washers.
Recommended products
AGIP GREASE PV 2 Multipurpose grease
NLGI 2 specifications; ISO-LXBIB2
Engine from vehicle APE TM Benzina
EV - 74
To Next Page
Loading...
Need help?
General
