Flywheel
FLYWHEEL - PULLEY - REMOVAL
Anchor the flywheel and the pulley dynamotor us-
ing the specific equipment (2), unscrew the nut (3)
of the pulley and the nut (6) of the flywheel.
Apply, through the 3 screws provided with the rel-
evant spacers interposed between the extractor
and flywheel in order not to interfere with the stator
coils, the specific equipment (4), and unscrew the
central screw (5) until the extraction has taken
place.
WARNING
TO CARRY OUT THE EXTRACTION OF THE DYNAMOTOR
PULLEY, IT IS NOT REQUIRED TO USE ANY TOOL, AS THE
DISASSEMBLY IS CARRIED OUT MANUALLY.
Specific tooling
T.0043062 Stop key of flywheel and dynamotor
pulley
T.0035731 Flywheel extractor and differential
housing
Crankcase splitting
DIFFERENTIAL HOUSING COVER AND SEPARATION OF HALF CRANKCASES
Remove the connecting nuts and bolts and, acting with a few mallet blows, remove the cover.
SEPARATION OF HALF CRANKCASES
Proceed as described above for the differential
cover, remember in particular that you can not de-
couple the engine crankcases before dismounting
the differential cover, which is necessary to loosen
the inner nut (1) connecting the half crankcases.
Engine APE TM Benzina
EN - 76
To Next Page
Loading...
Need help?
General
