VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
SHOULD THE VEHICLE CHANGE OWNER, IT IS ABSOLUTELY NECESSARY
THAT THE NEW OWNER GET POSSESSION OF THE KEY WITH THE BROWN
GRIP (AS WELL AS ALL OTHER KEYS).
Programming the immobilizer system (01_24)
Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
IZER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to "RUN".
PROCEDURE START
From the "CLOSE" position, insert the "MASTER" key and turn it to the "ON" position.
Leave the key in this position for 1 to 3 seconds, then return it to the "CLOSE" position
and remove the key.
INTERMEDIATE PHASE
After having removed the "MASTER" key, insert the secondary key to be programmed
within 10 seconds, and immediately turn it to the "ON" position. Leave the key in this
position for 1 to 3 seconds, then turn it to the "CLOSE" position and remove it. In this
way you can program up to 3 keys, by repeating the above operation and respecting
the indicated times.
FINAL PHASE
After having removed the key to be programmed, insert the "MASTER" key again and
turn it to the "ON" position (this operation must be completed within 10 seconds of
28
To Next Page
Loading...
Need help?
General