Procedurestart-redkey
Ensure that the emergency cut-off switch is in position "ON".
Insert the key with red grip into the key switch (in "OFF" position) and turn it to "ON".
After 1 - 3 seconds, turn the key to "OFF" again and pull it out.
Intermediatestep-blackkey
After pulling out the red key, insert the black key within 10 seconds and promptly turn
it to "ON". After 1-3 seconds, turn the key to "OFF"again and pull it out.
In this way, a maximum of 3 black keys can be programmed by repeating the above
procedure keeping the indicated times.
Finalstep-redkey
After pulling out the last black key, insert the red key again and turn it to "ON" (this
operation should be performed within 10 seconds of pulling out the previous key). Wait
about 1-3 seconds and return to "OFF" again.
01_14
Properprogrammingcheck (01_14, 01_15, 01_16)
Insert the red key disabling the transponder (i.e., tilt the key cap by 90°) and turn the
key to «ON». Perform the engine start-up operation. Check that the engine does not
start. Insert the black key and repeat the start-up operation. Check that engine starts.
WARNING
SHOULD THE ENGINE START WITH THE RED KEY (WITH TRANSPONDER OFF),
OR IN THE EVENT OF WRONG OPERATION DURING PROGRAMMING, REPEAT
THE PROCEDURE FROM THE BEGINNING.
16
To Next Page
Loading...
Need help?
General
