best performance (acceleration and consumption) while riding on both flat roads and
uphill.
If you have to stop on an uphill slope (traffic lights, traffic jam, etc.) use only the brake
to keep the vehicle still, leaving the engine running at idle speed. Using the
engine to keep the vehicle still can cause the clutch to overheat, due to the
friction of the clutch mechanism itself against the clutch bell.
It is therefore recommended to avoid conditions of prolonged clutch slippage (other
than those previously indicated) like driving uphill fully laden on steep slopes or starting
off with driver and passenger at slopes with steepness greater than 25%.
Observe the following precautions if the clutch overheats:
1. Do not continue riding in such conditions.
2. Let the clutch cool down with the engine at idle speed for a few minutes.
Safe driving
Some simple tips are provided below that will enable you to use your vehicle on a daily
basis in greater safety and peace of mind. Your skill and your mechanical knowledge
are the basis of safe riding. We recommend trying out the vehicle in traffic - free zones,
in order to acquire a good knowledge of the vehicle it self.
1. Before riding off, remember to put on your helmet and fasten it correctly.
2.Reduce speed on rough roads and drive with care.
3. After riding on a long stretch of wet road without using the brakes, braking can be
poor at the beginning. Given these conditions, it is a good idea to operate the brakes
from time to time.
4. Do not brake hard on wet, dirt or slippery road surfaces.
5. Avoid riding off by mounting the scooter when resting on the support. In any case,
the rear wheel should not be turning when in comes into contact with the ground, in
order to avoid abrupt departures.
6. When riding along roads covered by sand, mud, snow mixed with salt, etc. we
recommend cleaning the brake disc frequently with a non-corrosive detergent in order
37
To Next Page
Loading...
Need help?
General
