PicoScope 2200A Series User's Guide 11
Copyright © 2013 Pico Technology Limited. All rights reserved. ps2200a.en r1
3.5.4
AWG connector
The AWG connector on the front panel carries the output of the oscilloscope's built-in
signal generator, which can generate a number of built-in waveforms, as well as
arbitrary waveforms from a user-defined table of data.
Instructions for use
If you are using the PicoScope 6 program, refer to the PicoScope 6 User's Guide for
information on how to configure the signal generator.
If you are writing your own software, refer to either the:
PicoScope 2000 Series Programmer's Guide for PicoScope 2204A/5A, or
PicoScope 2000 Series (A API) Programmer's Guide for PicoScope 2206A/7A/8A
AWG output specifications
Refer to the PicoScope 2200A Series datasheet available on our website.
3.5.5
USB port
Connect the oscilloscope's USB port to your PC's USB 2.0 or USB 3.0 port using the
USB cable supplied. The oscilloscope will work if connected to a USB 1.1 port but will
operate at greatly reduced speed.
To Next Page
Loading...
Need help?
General
