Introduction4
Copyright © 2013 Pico Technology Limited. All rights reserved.ps2200a.en r1
2.1.4
Environment
WARNING
To prevent injury or death, do not use in wet or damp conditions, or around
explosive gas or vapor.
CAUTION
To prevent damage, always use and store your oscilloscope in appropriate
environments.
0 °C to +40 °C
(+20 to +30 °C for quoted accuracy)
5% to 95% RH
(non-condensing)
5% to 85% RH
(non-condensing)
2.1.5
Care of the product
The product contains no user-serviceable parts. Repair, servicing and calibration
require specialized test equipment and must only be performed by Pico Technology or
an approved service provider. There may be a charge for these services unless
covered by the Pico five year warranty.
WARNING
To prevent injury or death, do not use the product if it appears to be
damaged in any way, and stop use immediately if you are concerned by any
abnormal operations.
CAUTION
Do not tamper with or disassemble the oscilloscope, connectors or
accessories. Internal damage will affect performance.
CAUTION
When cleaning the product, use a soft cloth and a solution of mild soap or
detergent in water. Do not allow water to enter the oscilloscope casing, as
this will cause damage to the electronics inside.
2.2
Conformance
2.2.1
FCC notice
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his or her own
expense.
For safety and maintenance information see the safety warning.