SEARCH mode / multiple search
highlightThe optimised multiple search, the absolute of the PIEPS DSP, is based on
a separation of signals via the digital signal processor (DSP).
If there are multiple victims, this is clearly indicated by the number of matchstick men.
By default, the PIEPS DSP will automatically search for the strongest signal.
Once the position of the first victim has been located, press the MARK key for approx.
3 seconds without moving away from this point.
This signal is now suppressed and the device will automatically search for the second
strongest signal. In unfavourable circumstances (temporary signal interference), you
may have to repeat this procedure several times. Once a signal has been successfully
suppressed, an outline appears around the matchstick man.
Now continue the search as described above and repeat the procedures until all
transmitters are located.
IMPORTANT: In case of multiple detections involving older analogue devices,
faults may at worst occur which impair the efficiency of the digital signal
separation. In such cases, you may find for a short time that more signals are
displayed than actually exist.
To Next Page
Loading...
Need help?
General
