Pioneer CT-W851R User Manual

TROUBLESHOOTING
Symptom
Cause
Remedy
POOR SOUND QUALITY
L
Unstable or interrupted
sound
* The head, pinch rollers and capstans are ditty.
* The tape is not uniformly wound.
Clean {see page 4).
Completely fast-forward or rewind the tape.
No high frequencies
* A tape recorded without Dolby NR is being
played back with DOLBY NR switch in the B or
C position.
* The head is dirty.
Set DOLBY NR switch to OFF.
Clean the head isee page 4).
High frequencies are em-
phasized.
* A Dolby NR-encoded tape is being played back
with DOLBY NR switch in the OFF position.
Set DOLBY NR switch to the same position
used for recording.
| Sound from previous
recordings remains when
|_ferecording a tape.
* The head is dirty.
Clean the head {see page 4).
The sound is distorted.
* Recording level is too high.
The recorded signal itself is distorted.
* The head is dirty.
Turn REC LEVEL control down when recording
{see page 14).
Replace the cassette.
Clean the head {see page 4).
Too much noise
* Hi noise tape is being used.
* Incomplete insertion of a connection cord, poor
contact.
* Recording level is too low.
* The head is dirty.
* The head is magnetized.
Replace the cassette,
Check connections (see page 6),
Turn REC LEVEL control up when recording
(see page 14).
Clean the head (see page 4).
Demagnetize with a head demagnetizer.
cin
OTHERS
|
The music search func-
tion does not work.
* Blanks between selections are less than 4 se-
conds tong.
Use a tape with blanks more than 4 seconds
long.
Recording or playback
starts suddenly when
turning power on.
* TIMER switch is set to the PLAY or REC po-
sition.
Set TIMER switch to OFF.
Cannot use the remote
control system (Except
for CT-W851R),
* The control cord is not connected.
Connect the control cord (see page 6).
CD*DECK SYNCHRO is
disabled.
* The components are not connected properly.
* The cassette erasure prevention tabs are
broken
|
Connect them properly (see page 6),
Replace the cassette with one whose tabs are
intact.
The CD SYNC indicator
is off during CD* DECK
SYNCHRO recording.
* The tape ran out during the CD*DECK SYN-
CHRO mode.
* After the deck entered recording standby
mode, more than 1 minute elapsed before the
CD player resumed playback.
Replace the tape with a longer one.
Change the disc and press the CD SYNCHRO
button again.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet as
this
could
cause
a
short
circuit
or
electric
shock.
Do
not
place
the
unit,
a
piece
of
furniture,
etc.,
on
the
power
cord,
or
pinch
the
cord.
Never
make a knot in the cord or tie it with other cords. The power cords
should be routed such that they are not likely to be stepped on. A
damaged
power
cord
can
cause
fire
or
give
you
an
electrical
shock.
Check
the
power
cord
once
in
a
while.
When
you
find
it
damaged,
ask
your
nearest
PIONEER
authorized
service
center
or
your
dealer
for
a
replacement.
21
<RRB1120>
En

Pioneer CT-W851R Specifications

General

Brand	Pioneer
Model	CT-W851R
Category	Cassette Player
Language	English