Pioneer F-208 Operating Instructions

12
En
10 stations can be preset in each of the 3 classes, for a
total of 30 station presets.
NOTES:
¶ You can also store MPX MODE and RF ATT settings in
memory.
¶ If a station is memorized with the STATION CALL but-
tons at a position where a station is already memo-
rized, the previous contents are erased and the new
data is stored in memory.
¶ If preset stations get erased, repeat the preset proce-
dures from the beginning.
1. Tune in the desired station.
For details concerning tuning, refer to “BASIC TUN-
ING OPERATIONS” on P.10 and 11.
2. Press the MEMORY button.
¶ The MEMORY indicator will light for several sec-
onds.
¶ Memory storage is not possible once the indicator
goes off. In this case, press the MEMORY button
again.
¶ If the button is pressed again while the indicator is
lit up, the memory function will be canceled.
3. Select the desired class (A to C) with
the CLASS button.
4. While the MEMORY indicator is lit, press
the desired STATION CALL button.
Pressing a STATION CALL button causes the
MEMORY indicator to go out and the station to be
preset.
A station is preset (memorized) a few seconds after
pressing the STATION CALL button.
5. Repeat procedure 1 to 4 to memorize
other stations.
PRESET STATIONS
MEMORY
4.
2.
3.
CLASS
5
<Example> Presetting an FM 106.00 MHz
station into Class C with station no. (CH) 5.
4
3
2
MPX MODE
RF ATT
PRESETTING STATIONS

Pioneer F-208 Specifications

General

Brand	Pioneer
Model	F-208
Category	Car Receiver
Language	English