6
S-RS3SW
1
2 3 4
A
B
C
D
E
F
1
2 3 4
2.2 PANEL FACILITIES
1
POWER ON
POWER
VOLUME
MAX
MIN
AC IN
ON
OFF
200 Hz
50 Hz
CROSSOVER
BYPASS
PHASE
LINE LEVEL
INPUTOUTPUT
3
5
7
4
6
8
9
2
FRONT PANEL
REAR PANEL
2 Power switch (POWER)
Switches the subwoofer between ON and OFF.
3 Volume knob (VOLUME)
Sets the subwoofer volume.
• Turn the knob slowly from the MIN position.
• With this unit, the bass level can be independently set,
so do not turn up the bass on the AV amplifier.
1 Power Indicator (POWER ON)
Lights green when the power has been switched ON.
NOTE:
• If you are planning on switching the unit OFF for a long
period of time, make sure to check that the indicator light
has gone out after switching OFF.
4 Crossover knob (CROSSOVER)
When using the subwoofer, set the upper frequency limit
for the subwoofer (50 Hz to 200 Hz) so that it complements
the output from your other speakers.
When using the bass management features of an AV
receiver, set to BYPASS ON in order to use the low-pass
filter of the AV receiver for high quality sound.
5 Bypass switch (BYPASS)
When set to ON, the audio signal is routed directly to the
woofer unit, bypassing the amplifier’s filter.
6 Phase switch (PHASE 0º /180º)
When set to 180º, the output phase becomes the reverse
of the input signal, and when set to 0º, it is in the same
phase as the input signal.
• Normally, the switch is set to 0º.
But when the sound connection between the subwoofer
and the left and right speakers sounds unnatural,
try switching to 180º and set the switch in the position
where the sound is natural.
• When using two or more subwoofers together, make
sure that the phase switch of all of them are set to the
same position.
7 Line Level Input terminal (LINE LEVEL INPUT)
Connect to the SUBWOOFER PREOUT terminal of an
amplifier or receiver, with a RCA plug cord.
8 Line Level Output terminal
(LINE LEVEL OUTPUT)
Used for connecting other equipment through the ampli-
fier. The signal output from this jack is not affected in any
way by the settings of the various controls on the unit.
9AC IN
• Connect the power cord to the powered subwoofer
unit’s AC IN.
• Connect the power cord to a AC socket.
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
Need help?
General
