29
FEATURES
QUICKDRIVE Belt
The QUICKDRIVE drive system (if equipped) utilizes a drive belt that
exhibits extraordinary performance and service life when the belt is
handled properly before and during installation. Improper handling of
this belt can result in a shortened service life.
Inspect and change the belt at the intervals outlined in the Periodic
Maintenance Table beginning on page 80. See page 99 for inspection
procedures.
Special tools are required to remove and install the QUICKDRIVE belt.
Please see your POLARIS dealer for this service, or refer to the
instructions provided with the purchase of a new belt.
Belt Handling
• Store a new belt in original
packaging. Remove only when ready
for installation.
• Avoid belt contact with solvents, oils
or chemical cleaners.
• Do not crimp or bend the belt to a
diameter less than the upper sprocket.
• Do not back-bend the belt.
• Do not twist or flip the belt.
• Do not use a pry bar or screwdriver to
remove or install the belt.
• Always break in a new belt properly.
See page 67 for belt break-in
procedures.
To Next Page
Loading...
Need help?
General
