33
FEATURES AND CONTROLS
Seat Belts
Seat Belt Inspection
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate
must slide smoothly into the buckle. A click indicates that it's
securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt com-
pletely out and inspect the
full length for any damage,
including cuts, wear, fray-
ing or stiffness. If any
damage is found, or if the
seat belt does not operate
properly, have the seat belt
system checked and/or
replaced by an authorized
POLARIS dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with
mild soap and water. Do not use bleach, dye or household deter-
gents. Rinse the entire length of the belt webbing. Use a garden
hose to flush out the retractor and latch housings regularly.
To Next Page
Loading...
Need help?
General
