91
MAINTENANCE
Clutch System
n Drive Belt Condition
Belt width and length must match the center distance of the clutches and
sheave width of the drive clutch. For this reason, Polaris recommends
that only O.E.M. belts be used. Other belts may match the dimensions,
but can drastically change the shift pattern, resulting in poor perfor-
mance. See Belt Troubleshooting on page 118.
Periodically check the condition and tension of the drive belt. Inspect
the belt for signs of excessive wear: frayed edges, missing cogs, cracks
and excessive looseness. Replace the belt if any of these conditions
exist.
NOTE: A worn belt will continue to function, but will not deliver maxi-
mum performance. Always carry a spare belt in case of an
emergency.
For improved drive-away during extremely cold temperatures, remove
the belt and warm it to room temperature. Reinstall it before starting the
snowmobile.
To Next Page
Loading...
Need help?
General
