92
MAINTENANCE
Clutch System
Drive Belt Removal
1. Stop the engine after operating in a forward motion.
2. Turn the ignition key off. Wait for the engine to stop completely.
3. Lock the parking brake (if equipped).
4. Open the hood.
5. Remove the clutch guard retain-
ing pin and open the clutch
guard.
6. Locate the L-wrench in the tool
kit and install it into the open
threaded hole in the outer sheave
of the clutch. Rotate the wrench
until the sheaves open far enough
to remove the belt.
7. Firmly grasp the belt midway
between the clutches and pull
upward and rearward to remove.
See illustration.
CAUTION
Do not attempt to remove the drive belt after operating in reverse. The snow-
mobile must be stopped after forward motion to prevent damage to compo-
nents during belt removal.
To Next Page
Loading...
Need help?
General
