Polaris 360 User Manual

English
10
When operating correctly, the Polaris
®
cleaner vacuums, sweeps and scrubs all surfaces
randomly throughout the pool. The climbing ability depends on the pool’s shape and water
pressure or flow. The Polaris cleaner climbs best in pools without sharp angles or curves
in the transition from the pool floor to the pool wall. Approximately every 3-1/2 minutes the
Polaris cleaner goes into back-up mode. This action pulls the Polaris cleaner away from pool
obstacles.
The sweep hose should move in a gentle sweeping motion. To increase or
decrease sweeping motion:
1. Turn the filtration pump OFF.
2. Turn the adjustment screw on the feed pipe (r) counterclockwise to
increase sweep hose motion. Turn the adjustment screw clockwise to
decrease motion.
Decrease
motion
Increase
motion
If the cleaner is veering left or right instead of tracking straight, adjust the
thrust jet (on the back of the cleaner body) for climbing walls or turning.
Fine Tuning the Cleaner
1
Adjust the Sweep Hose
2
Adjust the Thrust Jet
Fine tune your cleaner by adjusting the sweep hose or the
thrust jet as necessary, for optimal operation.
P
u
s
h
e
s
U
n
i
t
L
e
f
t
P
u
s
h
e
s
U
n
i
t
R
i
g
h
t
12
6
39
I
n
c
r
e
a
s
e
s
C
l
i
m
b
i
n
g
D
e
c
r
e
a
s
e
s
C
l
i
m
b
i
n
g
11
11
NOTE: Factory default setting is
eleven o’clock. Only adjust thrust
jet to accomodate unique pool
shapes.

Polaris 360 Specifications

General

Brand	Polaris
Model	360
Category	Swimming Pool Vacuum
Language	English