English
14
Problem Solution
Cleaner does not climb walls. 1. Verify the wheel speed is 28 - 32 RPM.
2. Verify the thrust jet is in the 11 o’clock position.
3. Verify the head float is positioned all the way forward.
4. Verify the hoses have been cut correctly, following the
instructions.
5. With the pump running, turn the cleaner head upside
down. Verify the three vacuum jets have consistent
unobstructed flow. If not, contact customer service or a
Polaris
®
authorized service center for assistance.
Cleaner tires are slipping on tile or
fiberglass pool surface.
1. Verify your cleaner has Polaris PosiTrax
®
tires installed
on all three wheels. Polaris PosiTrax tires are only for
use on tile and fiberglass pool surfaces.
2. Verify the wheel speed is 28 - 32 RPM.
Wheels rotate less than 28 times
per minute
1. Verify the filter screen, pump baskets, and main filter
are clean.
2. Verify there are no leaks in the cleaner hoses, swivels,
or connectors.
3. If cleaner is installed on a dedicated cleaner line, adjust
the diverter valve to increase flow to the cleaner.
Wheels rotate more than 32 times
per minute
1. If cleaner is connected to a dedicated cleaner line,
adjust the diverter valve to reduce the water flow to the
cleaner.
2. Unscrew the pressure relief valve on the UWF
®
connector assembly until RPM is between 28 and 32.
To Next Page
Loading...
Need help?
General
