111
MAINTENANCE
General Maintenance
n Drive Belt Deflection
Measure belt deflection with
both clutches at rest and in
their full neutral position.
Place a straight edge (1) on the
belt and apply downward pres-
sure while measuring at point
2. This measurement should be
1 1/4I (3.2 cm).
Drive Belt Adjustment
TEAM Clutch
1. Loosen the 7/16I jam nut on the belt width adjuster.
2. Using a 1/8I Allen wrench, adjust the threaded set screw as needed.
NOTE: Turn the set screw in (clockwise) to increase the distance
between the sheaves and out (counterclockwise) to decrease
the distance.
3. Tighten the jam nut.
To r q u e S t o p
Periodically check torque stop clearance. With clutches in proper align-
ment, the clearance should be .010I-.030I (.25-.75mm) from the engine
case. Adjust if necessary. Lock the jam nut.
1
2
.010-.030I
(.25-.75 mm)
To Next Page
Loading...
Need help?
General
