Polaris 600 RMK 144 User Manual

84
MAINTENANCE
Brakes
n Hydraulic Brake Inspection
Inspect the brake lever travel before each use of the snowmobile. See
page 49.
Brake pads must be replaced when the brake pad material becomes thin-
ner than the backing plate, approximately 1/16" (1.5mm). A kit is avail-
able for replacing brake pads. See your dealer.
WARNING! Brake failure during operation can result in serious injury or death.
Properly functioning brakes are vital to your safety. Be sure the brake pads do
not drag on the disc and that brake lever travel is not excessive. Always replace
brake pads when the brake pad material becomes thinner than the backing
plate, approximately 1/16" (1.5mm).
Brake Components
•Brake Disc
• Bleed Screw
•Brake Line
• Brake Caliper
• Brake Pad Material -
Replace when thickness is
less than 1/16" (1.5mm).
Excessive Lever Travel
Hydraulic brakes are self-
adjusting, but if excessive
brake pad clearance develops
(see page 84) bring the snow-
mobile to an authorized
Polaris dealer for inspection
and adjustment.
Brake Disc
Bleed Screw
Brake Pad
Material
Brake Line
Brake Cal-
iper

Polaris 600 RMK 144 Specifications

General

Brand	Polaris
Model	600 RMK 144
Category	Offroad Vehicle
Language	English