Page 13
English
Figure 21. Spread Floating Cable Across Farthest
Distance of the Pool
Max
Floating Cable
Length
caddy /
control unit
cleaner
cleaner
Recommended
entry point
Not
Recommended
IMPORTANT
The floating cable may become tangled if correct
procedure is not followed.
Do not leave the cleaner unattended for prolonged
periods, always spread the oating cable over the pool,
and follow the procedure below to avoid excessive
tangling.
After every cleaning cycle:
1. Unplug power to the cleaner at the control unit.
2. Remove the cleaner from the pool and untangle
all kinks and coils in the oating cable starting
at the cleaner head (see Figure 22). Lay cable
in sunlight to loosen tangling memory in the
cable.
3. Plug power cord back into control unit and
store cleaner on the caddy out of direct sunlight
for next use.
Figure 22. Untangle the Floating cable
Cleaner
Control Unit /Caddy
5.2 Check for Brush Wear
The cleaner is tted with PVC brushes in front and
rear. There are raised grooves that are ''wear'' indicators
on the brushes located next to the tab connectors (see
Figure 23). As brushes wear out, the raised groove will
atten and smoothen into the track.
Figure 23. Wear Indicators
To Next Page
Loading...
Need help?
General
