Page 9
English
4. Spread the oating cable over the pool, making
sure there are no kinks or coils in the cable .
NOTE: For optimal patterning and reduced tangling, the
oating cable should enter the water near the
middle of the pool length. Only place enough
cable in the water to reach the farthest point in
the pool (see Figure 13).
Figure 13. Set Up for Optimal Patterning
Max
Floating Cable
Length
caddy /
control unit
cleaner
cleaner
Recommended
entry point
Not
Recommended
4.3 Starting the Cleaner
The rst time you use the cleaner, the cleaning surface
setting is Floor and Walls .
After the rst time, the default is the last setting used. .
Select Cleaning Surface:
• Use to change cleaning surface setting.
Begin Cleaning:
• After selecting the cleaning surface,
press to begin operation.
• At the beginning of the cycle, the cleaner
remains in place for a few seconds to initialize
the microcontroller after the pump starts.
NOTE: Periodically the cleaner will pause for up to 20
seconds throughout the cleaning cycle. The cleaner
is calibrating its position in the pool during this
process. This is normal operation and the cleaner will
resume movement immediately after calibration with
no user action required. The pause does not affect
the overall cleaning cycle.
4.4 Wall Climbing (Surface Control
System™)
The cleaner has the ability to clean the pool walls up to
the waterline. How much the cleaner needs to grip to the
wall depends upon the pool surface.
Grip Intensity Indicator:
Surface Control System (SCS) settings are as follows
for different pool surface types:
1 Pebble Surface (ROUGH)
2 Concrete
3 Vinyl / Fiberglass
4 Tile (SMOOTH)
Check Wall Climbing Setting:
• Start the cleaner and watch as the cleaner
climbs each wall. If grip setting is correct, the
cleaner will easily climb the wall and clean up
to the waterline. The default setting is
1 Pebble Surface (ROUGH)
2 Concrete
3 Vinyl / Fiberglass
4 Tile (SMOOTH)
NOTE: Wall climbing is programmed in a randomized
pattern. Cleaner may climb wall and not reach
waterline until third or fourth attempt in order
to thoroughly clean wall surface below the
waterline first.
• Adjust the wall climbing setting as necessary
using the following guidelines:
Increase: if cleaner is climbing the wall slowly
and stays below the waterline.
Decrease: if cleaner is climbing the wall too
quickly and sucking air at the waterline.
Adjust SCS Wall Climbing Setting:
You can change the wall climbing setting at any time
during cleaner operation with the SCS button. The new
setting will be active when the cleaner climbs the next
wall.
To Next Page
Loading...
Need help?
General
