110
MAINTENANCE AND LUBRICATION
Vehicle Immersion
If it’s impossible to take your ATV t o a dealer before starting it, follow
the steps outlined below.
1. Move the ATV to dry land or at the very
least, to water below the foot rests.
2. Turn the fuel valve off.
3. Remove the spark plug.
4. Check the air box and drain if water is
present.
5. Loosen the carburetor drain screw (1).
6. Turn the engine over several times using
the electric start.
7. Dry the spark plug and reinstall, or replace
it with a new plug.
8. Tighten the carburetor drain screw.
9. Turn the fuel valve on.
10. Attempt to start the engine. If necessary, repeat the drying
procedure.
11. Take the ATV to your dealer for service as soon as possible,
whether you succeed in starting it or not.
NOTE: If water has been ingested into the PVT, follow the procedure
on page 73 for drying out the PVT.
If your vehicle becomes immersed, major engine damage can
result if the machine is not thoroughly inspected. Take the vehicle
to your dealer before starting the engine.
CAUTION
1
To Next Page
Loading...
Need help?
General
