Polaris ATV 2001 User Manual

156
MAINTENANCE
High Beam Headlight Adjustment
The headlight beam can be adjusted up and down.
1. Place the vehicle on a level surface with the headlight approxi-
mately 25’ (7.6 m) from a wall.
2. Measure the distance from the floor to the center of the head-
light and make a mark on the wall at the same height.
3. Start the engine and turn the headlight switch to high beam.
4. Observe headlight aim. The most intense part of the headlight
beam should be aimed 2″ (5.1 cm) below the mark placed on
thewallinstep2. NOTE: Rider weight must be included on the
seat.
5. Loosen pivot bolt and adjust beam to desired position.
6. Tighten nut and bolt. Torque to 60 in. lbs.

Polaris ATV 2001 Specifications

General

Brand	Polaris
Model	ATV 2001
Category	Offroad Vehicle
Language	English