96
MAINTENANCE
Tools
An L-wrench and a tool kit (containing a spare belt, spark plug wrench
and provisions for two spare spark plugs) are provided with the
snowmobile. Open the left side panel to access the tools.
The L-wrench is used to open
and close the driven clutch
when working with the drive
belt. The L-wrench, when
properly engaged in the bracket,
secures the fender to the
console. To retrieve the L-
wrench, rotate it counter-
clockwise and slide it upward
from the bracket. When it’s not
in use, return the L-wrench to
the bracket and rotate it clockwise.
The tool kit is stored in a
container attached to the left
tube of the front bumper. Use
the following procedure to
remove the spare belt container
from the snowmobile.
1. Rotate the spark plug
wrench counter-clockwise
to release it from the
bracket.
2. Pull the wrench upward to
remove it.
NOTE: The wrench secures the
container to the bumper.
3. Tilt the tool kit container
until the bracket detaches
from the bumper tube.
To Next Page
Loading...
Need help?
General
