Polaris P94 User Manual

Page 14
English
Section 5. Programming the
Cleaner
(9400 Sport/P94 and 9500 Sport/P95 only)
You can program up to seven preset cleaning cycles to run
thecleaneronaspecicdayandtimewhenyouareaway
from the pool.
NOTE: You cannot change programming or display current
day and time during a cleaning cycle.
5.1 Displaying Current Day and Time
• Press to display current day and time in
24-hour clock format.
Current day and time is displayed for 5 seconds.
5.2 Changing the Clock Day and Time
1. Press and hold for three (3) seconds.
All days of the week ash twice.
2. Press or buttons to cycle through
seven (7) days and display desired day.
3. Press
to select.
Current hour setting ashes.
4. Press or buttons to cycle through
24 hours and display desired hour setting.
NOTE: Control unit is set to display time in 24-hour
clock format. Time setting will cycle through 1-24.
5. Press to select.
Current minutes setting ashes.
6. Press or buttons to cycle
through1-59minutesanddisplaydesired
minutes setting.
7. Press
to select.
8. Press
to set time and exit the menu.
9. Press
to display current day and time
setting and verify the time you set is correct.
5.3 Changing Default Cleaning Times
Use to change cleaning surface setting.
Default cleaning times are:
Bottom Only: 1 hour 30 minutes
Bottom and Sides:
2 hours 30 minutes
Waterline (9500 Sport/P95):
Variable cleaning time depending on settings
1. Press
or buttons to increase or
decrease cleaning time in 30-minute increments.
2. Press
to select.

Polaris P94 Specifications

General

Brand	Polaris
Model	P94
Category	Vacuum Cleaner
Language	English