Page 11
English
Display Current
Time/ Set Time
Program Cleaning
Cycles / Set Time
Navigate Day/Hour
Remove Cleaner
from Pool
Start/Stop Cleaner
Operation
Cancel Programming
Validate Time Setting
Selection
Select Cleaning Surface
Select Cleaning Level
Select Pool Shape
Dirty Filter
Indicator
4.4 The Polaris 9550 Sport/P955 Cleaner Control Unit
4.5 Starting the Cleaner
The default cleaning surface setting for the Polaris
cleaners is Bottom Surface
. To change the
current programmed cycle, see Section 5. Programming
the Cleaner.
Select Cleaning Surface (all models):
Use
to change cleaning surface setting.
Toggle between:
Bottom Only
Bottom and Sides
Waterline (9550 Sport/P955)
Select Cleaning Intensity Level
(9550 Sport/P955 only):
Use
to choose cleaning intensity level.
Toggle between:
INTENSIVE
HIGH INTENSITY
Select Pool Shape (9550 Sport/P955 only):
Use
to choose pool shape.
Toggle between:
RECTANGULAR
FREEFORM
Begin Cleaning:
After selecting the cleaning surface and other options as
applicable, press
to begin operation.
The screen displays the time remaining for the selected
cycle. For example, 0:44 on the display indicates that
cleaning will be completed in 44 minutes.
NOTE: The control unit automatically switches to standby
power mode after 10 minutes of inactivity and the
display screen turns off. Press any key to exit standby
mode. Cleaner will continue to function in standby
mode if in the middle of a cleaning cycle.
To Next Page
Loading...
Need help?
General
