116
MAINTENANCE AND LUBRICATION
Engine Cooling System
Radiator Coolant Level
NOTE: This procedure is required only if the cooling system has been drained for
maintenance and/or repair. However, i f the recovery bottle has run dry, inspect the l evel in
the radiator and add coolant if necessary.
1. Remove the pressure cap.
2. Using a funnel, slowly add coolant as necessary through the radiator filler neck.
3. Replace the pressure cap.
NOTE: Use of a non-standard pressure cap will not allow the recovery system to function
properly. Contact your dealer for the correct replacement part.
WARNING
Escaping steam can cause severe burns. Never remove the pressure cap while the
engine is warm or hot. Always allow the engine to cool before removing the cap.
To Next Page
Loading...
Need help?
General
