24
FEATURES AND CONTROLS
Brake Pedal
Depress the brake pedal to slow or stop the vehicle. Apply the brakes while starting the
engine.
Throttle Pedal
Push the pedal down to increase engine speed.
Spring pressure returns the pedal to the rest
position when released. Always check that the
throttle pedal returns normally before starting
the engine. Make sure there's adequate throttle
pedal freeplay. See page 72 for throttle pedal
adjustment procedures.
Fuel Cap
The fuel tank filler cap is located on the right-hand
side of the vehicle near the passenger seat. When
refueling, always use either leaded or unleaded
gasoline with a minimum pump octane number of
87 R+M/2 octane. Do not use fuel with ethanol
content greater than 10 percent, such as E-85 fuel.
Seat Removal
Pull up on the front of the seat and slide it toward
the front of the vehicle. Install the seat by sliding
the tabs into the rear of the seat base. Push down
firmly on the front of the seat until the pins are
fully seated into the grommets.
Electronic Power Steering (EPS)
Electronic power steering (if equipped) engages when the ignition key is turned to the ON
position. EPS remains engaged whether the vehicle is moving or idle.
To conserve battery power, the EPS will shut down 5 minutes after the engine is stopped if
the key remains in the ON position. The EPS warning indicator will illuminate to indicate the
EPS has shut down. Turn the key off and on to reset the unit.
See page 28 for EPS warning indicator information.
To Next Page
Loading...
Need help?
General
