76
MAINTENANCE
Brakes
The front and rear brakes are hydraulic disc type brakes. Press down on the brake pedal to
engage the brakes. See page 25.
Brake Fluid
Inspect the brake system routinely. Inspect the level of the brake fluid before each operation.
WARNING! After opening a bottle of brake fluid, always discard any unused portion. Never store or
use a partial bottle. Brake fluid is hygroscopic, meaning it rapidly absorbs moisture from the air. The
moisture causes the boiling temperature of the brake fluid to drop, which can lead to early brake fade
and the possibility of accident or severe injury.
Change the brake fluid every two years and any
time the fluid becomes contaminated, the fluid
level is below the minimum, or if the type and
brand of the fluid in the reservoir are unknown.
See page 61 for fluid recommendations.
1. Position the vehicle on a level surface.
2. View the brake fluid level at the reservoir
in the driver’s side wheel well. The level
should be between the upper (MAX) and
lower (MIN) level lines.
3. If the fluid level is lower than the upper
level line, open the hood and add brake
fluid to the upper (MAX) line.
4. Apply the brake forcefully for a few
seconds and check for fluid leakage around
the fittings.
Brake Inspection
1. Check the brake system for fluid leaks.
2. Check the brake pedal for excessive travel or a
spongy feel.
3. Check the friction pads for wear, damage and
looseness.
4. Check brake discs for signs of cracks, excessive
corrosion, warping or other damage. Clean any
grease using an approved brake cleaner or alcohol.
WARNING! Do not apply WD-40 or any petroleum product
to brake discs. These types of products are flammable and
may also reduce the friction between the brake pad and
caliper.
5. Inspect the brake disc spline and pad wear surface for excessive wear. Change pads when
worn to .030” (0.762 mm).
Brake Fluid
Reservoir
.030” (0.762 mm)
To Next Page
Loading...
Need help?
General
