TROUBLESHOOTING
VEHICLE WILL NOT OPERATE
POSSIBLE CAUSE SOLUTION
Low battery voltage Recharge the battery overnight
Loose battery connections Check all connections and tighten
Loose contactor connections Check all connections and tighten
Loose electronic control box
connections
Inspect, clean, reinstall connectors
Required torque exceeds motor
capability
Apply the brakes and select low
range
MALFUNCTION INDICATOR
TROUBLESHOOTING
The malfunction codes will blink on the controller. The code definitions provided
here are for informational purposes only.
TIP
If the indicator illuminates due to a minor issue such as a low voltage condition
or a sequence fault (reversing direction without releasing the accelerator),
select neutral and turn the key off and on to clear the error. If the error does not
clear, please see your POLARIS dealer for diagnosis and repair.
# OF BLINKS CODE DEFINITION
1 Data or configuration error
2 Sequence fault
3 Power fault
4 Contactor issue
6 Throttle input error
7 Voltage protection
8 Controller or motor out of temperature range
13 Software fault
107
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
