CHARGE STATUS INDICATOR
When charging the batteries, the charge status indicator light flashes and
changes color to indicate the status of the charge. Refer to the table below.
Color Indication Code Definition
Green Solid Charge is complete, charger is in maintenance mode.
Green Fast Flash Less than 80% of charge is completed.
Green Slow Flash More than 80% of charge is completed.
Amber Flashing Power mode is reduced, low AC voltage or high
internal charger temperature exists; open hood to
improve air flow.
Red Flashing Charger error exists; reset charger power and refer to
Troubleshooting section of owner’s manual
SWITCHES
KEY SWITCH
Turn the key to the ON position to activate the electrical circuits. Turn the key to
the OFF position to disable all electrical circuits. The key can be removed from
the switch when it is in the OFF position.
DIRECTION SELECTOR SWITCH
When the direction selector is in the
center position, the vehicle is in neutral.
The vehicle will not move if the
accelerator pedal is depressed. Push
the top of the switch to choose forward
operation. Push the bottom of the
switch to choose reverse operation. If
the switch is changed while the
accelerator pedal is depressed, the
vehicle will not move in the new
direction until the pedal is released,
then depressed again.
TIP
The malfunction light will illuminate after reversing direction if you fail to
release the throttle pedal after changing the switch.
38
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
