274 Parking
A - Programable keypad
B - Light-emitting diode for status identification
Garage Door Opener
The programable garage door opener in your
Porsche replaces up to three original hand-held
transmitters used to operate a variety of devices
(e.g. garage door, gate to the property, alarm
system).
You have the option of programming each individ-
ual key in key pad A with an original hand-held
transmitter frequency.
Warning!
Risk of accident when using the garage door
opener if persons, animals or objects are
within the range of movement of the equip-
ment that is being operated.
f When using the garage door opener, ensure
that no persons, animals or objects are within
the range of movement of the equipment that
is being operated.
f Observe the safety notes for the original hand-
held transmitter.
To operate the device in question
(e.g. garage door, gate to the property,
alarm system):
f Press the relevant button in keypad A.
Light-emitting diode B lights up during the
signal transfer.
Notes on operation
f Always use the garage door opener in the di-
rection of travel.
Otherwise, range restrictions cannot be ruled
out.
f Before selling the vehicle, delete the pro-
gramed signals in keypad A of the garage door
opener.
f Please read the instructions for the original
hand-held transmitter to find out whether the
original transmitter is equipped with fixed or
changeable code.
Deleting programed signals
(e.g., when selling the vehicle)
This process deletes the standard codes set at
the factory. Do not repeat the process if you pro-
gram further buttons
f Keep the two outer buttons of key pad A
pressed for approx. 20 seconds until light-
emitting diode B begins to flash.
All programed signals are deleted.
To Next Page
Loading...
Need help?
General
