Poulan Pro PPBP30 User Manual

4 - FUEL AND LUBRICATION
4-1. FUELING ENGINE
WARNING: Remove fuel cap slowly when
refueling.
This engine is certified to operate on unleaded
gasoline. Before operation, gasoline must be
mixed with a good quality synthetic 2-cycle
air-cooled engine oil designed to be mixed at a
ratio of 40:1. PoulanAA/EED EATER brand
synthetic oil is recommended. Mix gasoline and oil
at a ratio of 40:1. A 40:1 ratio is obtained by
mixing 3.2 fluid ounces (95 mi) of oil with 1 gallon
(4 liters) of unleaded gasoline. DO NOT USE
automotive oil or marine oil. These oils will cause
engine damage. When mixing fuel, follow
instructions printed on container. Once oi! is
added to gasoline, shake container momentarily
to assure that the fuel is thoroughly mixed. Always
read and follow the safety rules relating to fuel
before fueling your unit.
CAUTION: Never use straight gasoline in your
unit. This will cause permanent engine damage
and void the warranty.
4-2. FUEL REQUIREMENTS
This engine requires the use of minimum 87
octane [R+M]/2 clean gasoline.
IMPORTANT
Use of alcohol blended fuels (called gasohol or
using ethanol or methanol) can cause major
engine performance and durability problems.
WARNING: Alternative fuels (not gasoline) such
as E-15 (15% alcohol), E-20 (20% alcohol), E-85
(85% alcohol) are NOT classified as gasoline and
are NOT approved for use in 2-stroke gasoline
engines. Use of alternative fuels will cause
problems such as: improper clutch engagements,
overheating, vapor lock, power loss, lubrication
deficiency, deterioration of fuel lines, gaskets and
internal carburetor components, etc. Alternative
fuels cause high moisture absorption into the
fuel/oil mixture leading to oil and fuel separation.
4-3. FUEL AND LUBRICATION SYMBOLS
FUEL MIXING TABLE
GASOLINE
40:1 Ratio
Lubricant
1 U.S. Gal.
3.2 oz.
95ml (cc)
5 Liters
4.3 oz.
125ml (cc)
1 Imp. Gal.
4.3 oz.
125mi (cc)
Mixing
40 Parts Gasoline to
Procedure
1 Part Lubricant
1ml=1cc
5 - STARTING/STOPPING INSTRUCTIONS
5-1.1. STARTING A COLD ENGINE
NOTE: This product is designed to be started at
idle.
1. Pump primer bulblO X by pressing up on the
buib(D). (Fig. 5-1B)
2. Your unit is designed with a 3-position choke:
FULL CHOKE "H", HALF CHOKE H N” and
RUN “HP.
Move choke lever to FULL CHOKE 11 H ”
position. (Fig. 5-1 A)
NOTE: Easy Start power assist starting
significantly reduces the pulling effort. Pull the
starter cord slowly toabout 3 1/2 feet, the power
assist will turn over the enginewith little resistence
from the engine.
3. Squeeze throttle trigger and turn throttle
adjuster clockwise until it stops.
Throttle adjuster position:
(1) Idling
(2) Full Throttle
Fig. 5-1C)
4. With the unit on the ground,hold the top assist
handle and step on the bottom of the frame
with your foot. (Fig.5-1D)
7

Poulan Pro PPBP30 Specifications

General

Brand	Poulan Pro
Model	PPBP30
Category	Blower
Language	English