01527-02-04
Compact
Range
Owner’s Manual
Battery Care
Lithium Battery 18 Hole/36 Hole
Lithium Isolation Switch (1)= on (0)= off
0 1
PLUG’ n ’ PLAY
TM
Your C2i trolley features an innovative Plug’n’Play™ battery system. To
maximise your battery life please take time to read the following battery
care and charging instructions.
Batteries available are as follows:
Lithium 18 Hole Lithium Extended 36 Hole*
*In normal conditions the Extended batteries will do 36 holes when used
on a PowaKaddy trolley. Conditions such as long or exceptionally hilly
courses, wet ground conditions and excessively heavy golf bags may
reduce the range of the battery.
6
More game-changing technology at www.powakaddy.com
Tools Required:
Pozi PZ2
Screwdriver
The accessory bracket for your Compact C2 is supplied with your
trolley in the box. Attach bracket to upper tubes as shown below.
Orientate the bracket to follow
the curvature of the handle.
7
Accessory Bracket Fitting Instructions
.
Should you experience a problem with your PowaKaddy product please go to www.powakaddy.com/support
Your PowaKaddy trolley is simple to maintain.
Never jet wash your trolley or immerse into water. Occasionally remove the wheels and apply grease to the axle and moving parts.
Your serial number can be found on the underside of the main body chassis. Keep a note of the serial number for reference in the
box provided above.
Maintenance
Important Safety Information about Batteries & Chargers
Never submerge the battery in water.
Never leave the battery in the trolley when cleaning the frame.
If you suspect your lithium battery has water inside do not use or attempt to recharge.
Never use the charger or battery if the leads, contacts or casings are damaged.
Dropping the battery may damage the cells or circuit components inside
A LITHIUM BATTERY THAT HAS BEEN SUBMERGED IN WATER OR SUSTAINED DAMAGE IS A FIRE HAZARD. DO NOT USE
THE BATTERY. Place outdoors in a non-combustible container well away from flammable materials. DO NOT RECHARGE THE
BATTERY. If you consult a Service Agent, you must explain what has happened. We recommend disposing safely at your local
recycling centre.
Avoid charging your Lithium battery in temperatures below 0 ˚C or exposing the battery to temperatures below -5 ˚C or above 40 ˚C.
Always place the charger on a hard, flat heat resistant surface. Do not wrap or cover as the charger generates heat during use.
Never expose the charger to rain, moisture or damp. If you suspect any of these have occurred then do not use the charger.
Only charge your battery using the compatible PowaKaddy charger provided with your battery.
Never discharge your battery other than in normal use on the trolley.
Always check with your airline before attempting to transport batteries by air.
Place your battery and charger on a hard level surface and connect the battery and charger first before plugging in the mains power
and switching on.
Only charge your Plug’n’Play Lithium battery with the isolation switch in the ON (1) position.
The charger has 2 indicator lights to represent the status of the battery during the charging process. When connecting a
discharged battery, the red light will illuminate to indicate the bulk charge state. When the bulk charging process is complete, the
green light will illuminate. The battery should be removed from the charger after the green light is active.
Never leave the charger connected to the battery with the mains supply switched off.
We recommend you recharge your battery within 24 hours of use, no matter how many holes played.
This may take up to 7 Hours for a Lithium battery depending on the capacity of the battery and depth of discharge when charging.
Never leave your battery in a discharged condition for prolonged periods, this will reduce the life of the battery and your charger
may be unable to recharge it.
If the battery is not to be used for a long period, our advice is to store in a cool dry place. Please ensure the battery is fully charged
before storing and charge every month thereafter.
Ensure your Lithium battery isolation switch is in the OFF (0) position during transportation.
Please refer to the product labels on your battery and charger for more information.
At the end of the battery’s life, dispose at your local recycling centre.
Charging Your Lithium Battery
SN:
All PowaKaddy electric trolleys
have been awarded the Quiet Mark
by the Noise Abatement Society
Understanding the Battery Gauge:
The battery gauge on the C2i is similar to a car fuel gauge - F (full), ½ (half
full) & E (empty). There are five blue bars and depending on the charge state
of your battery will determine how many bars illuminate. When a fully charged
battery is connected to the trolley all five blue bars will illuminate.
As you progress through your round the blue bars will extinguish from full to
empty. When the fifth blue bar is extinguished it indicates that the battery is
flat. When your battery is new you may lose only one or two bars during the
entire round. As your battery ages, you may lose more bars.
If you lose all the blue bars this could indicate; (1) you have not fully charged
your battery (2) your battery is nearing the end of its useful life and you should
consider buying a replacement.
Automatic Distance Function (ADF):
The ADF function is a convenient way of sending your trolley a set distance.
(15, 30, 45 yards or metres) For example when you are approaching a green
you can send the trolley towards the next tee if the route allows. Please note
it is not recommended to send your trolley unattended over steep or rough
terrain. To activate when the motor is paused:
1: Press and hold the central control knob until ‘ADF’ appears on the display
2: Rotate the control knob to select the distance between 15 to 45 Yrds/
Metres.
3: To start the function press the control knob.
4: To cancel rotate the Central Control Knob to “00” and select by pressing
WARNING! Before using the ADF function please ensure the route is clear from
any obstacles. To interrupt the distance function when in operation press the
on/off button to stop the motor function.
**Please note ADF distance are approximate based on flat level terrain conditions using a fully charged battery.
The overall distance may be affected by terrain conditions, obstacles or incline, battery power and weight of golf
bag
Factory Settings
Your new C2i trolley is ready to use, but there are a number of preferences
you can change in the programming mode. To enter programming mode:
1: Connect the battery to the trolley.
2: With the trolley powered and the default display shown press and hold
both function buttons for 3 seconds. The main features on the display will be
replaced by the clock flashing in the top left hand corner of the display.
3: Press the right function button to scroll through the options.
4: Select or modify the option by pressing the central control knob, then use
the dial to adjust the setting or input values.
5: Press and hold both function buttons to save and exit after changing any
settings. The display will then return to the default display.
Each of the Factory Settings are detailed below:
Time: With the clock flashing rotate the control knob to the required digit and
press to save each digit.
COMP Mode: With ‘COMP’ highlighted on the display press the control knob
to turn the ‘competition’ mode on and off. This will disable ADF, distance
functions measurement.
Security Pin: With the padlock icon highlighted you can turn the PIN
function on and off by pressing the central control knob. To select your
security PIN rotate the control knob to select your 4 digit code, save each
digit by pressing the control knob. Repeat for each digit and then press and
hold both buttons to save the new PIN.
Note: if you have added a PIN lock this will be required every time you turn
the trolley on. In the event you have forgotten your PIN you can use the
default factory PIN: 7921 to unlock the controls.
ADF Indicator
Battery Gauge
Clock
Competiton Mode
ADF Distance
Yards/Metres
To Next Page
Loading...
Need help?
General
