6
Electronic Braking System
The Electronic Braking System is an optional extra within the Compact Range.
The EBS has the added advantage of an Electronic Braking System (EBS) for hill
decent control thus creating the ultimate machine for all conditions.
To activate the braking function:
1: Ensure the motor and power is on.
2: Rotate the control knob counter-clockwise until you go below zero. The
EBS logo will appear next to the power setting to indicate the braking function,
which will display between 1, 2 and 3 indicating the level of braking force being
applied, 3 being the highest.
3: Rotate the control knob clockwise to return to normal power settings.
Note: you do not have to pause the trolley between the standard power and
EBS braking mode
WARNING! EBS is an assisted braking system for hill descent not a 100% parking brake. The trolley must be powered on and
the wheels engaged with the clutch for the braking system to function. The drive system uses a limited slip differential to allow
braking and provide ease of manoeuvrability. Try to avoid traversing a steep hill as the load of the trolley will mostly be applied
to the lower wheel on the slope, and may cause the higher wheel to slip. If your trolley loses traction and the wheels start to
spin apply more even pressure on the handle to increase traction of both wheels. Engage the braking progressively as you
descend a slope.
Caution: Wet or loose ground can cause the wheels to lock and slip on steep slopes. When using the maximum braking force
always maintain a firm grip on the handle to assist the trolley and avoid injury or damage.
EBS symbol indicates braking function active
01527-02-04
Compact
Range
Owner’s Manual
Battery Care
Lithium Battery 18 Hole/36 Hole
Lithium Isolation Switch (1)= on (0)= off
0 1
PLUG’ n ’ PLAY
TM
Your C2i trolley features an innovative Plug’n’Play™ battery system. To
maximise your battery life please take time to read the following battery
care and charging instructions.
Batteries available are as follows:
Lithium 18 Hole Lithium Extended 36 Hole*
*In normal conditions the Extended batteries will do 36 holes when used
on a PowaKaddy trolley. Conditions such as long or exceptionally hilly
courses, wet ground conditions and excessively heavy golf bags may
reduce the range of the battery.
6
More game-changing technology at www.powakaddy.com
Tools Required:
Pozi PZ2
Screwdriver
The accessory bracket for your Compact C2 is supplied with your
trolley in the box. Attach bracket to upper tubes as shown below.
Orientate the bracket to follow
the curvature of the handle.
7
Accessory Bracket Fitting Instructions
.
Should you experience a problem with your PowaKaddy product please go to www.powakaddy.com/support
Your PowaKaddy trolley is simple to maintain.
Never jet wash your trolley or immerse into water. Occasionally remove the wheels and apply grease to the axle and moving parts.
Your serial number can be found on the underside of the main body chassis. Keep a note of the serial number for reference in the
box provided above.
Maintenance
Important Safety Information about Batteries & Chargers
Never submerge the battery in water.
Never leave the battery in the trolley when cleaning the frame.
If you suspect your lithium battery has water inside do not use or attempt to recharge.
Never use the charger or battery if the leads, contacts or casings are damaged.
Dropping the battery may damage the cells or circuit components inside
A LITHIUM BATTERY THAT HAS BEEN SUBMERGED IN WATER OR SUSTAINED DAMAGE IS A FIRE HAZARD. DO NOT USE
THE BATTERY. Place outdoors in a non-combustible container well away from flammable materials. DO NOT RECHARGE THE
BATTERY. If you consult a Service Agent, you must explain what has happened. We recommend disposing safely at your local
recycling centre.
Avoid charging your Lithium battery in temperatures below 0 ˚C or exposing the battery to temperatures below -5 ˚C or above 40 ˚C.
Always place the charger on a hard, flat heat resistant surface. Do not wrap or cover as the charger generates heat during use.
Never expose the charger to rain, moisture or damp. If you suspect any of these have occurred then do not use the charger.
Only charge your battery using the compatible PowaKaddy charger provided with your battery.
Never discharge your battery other than in normal use on the trolley.
Always check with your airline before attempting to transport batteries by air.
Place your battery and charger on a hard level surface and connect the battery and charger first before plugging in the mains power
and switching on.
Only charge your Plug’n’Play Lithium battery with the isolation switch in the ON (1) position.
The charger has 2 indicator lights to represent the status of the battery during the charging process. When connecting a
discharged battery, the red light will illuminate to indicate the bulk charge state. When the bulk charging process is complete, the
green light will illuminate. The battery should be removed from the charger after the green light is active.
Never leave the charger connected to the battery with the mains supply switched off.
We recommend you recharge your battery within 24 hours of use, no matter how many holes played.
This may take up to 7 Hours for a Lithium battery depending on the capacity of the battery and depth of discharge when charging.
Never leave your battery in a discharged condition for prolonged periods, this will reduce the life of the battery and your charger
may be unable to recharge it.
If the battery is not to be used for a long period, our advice is to store in a cool dry place. Please ensure the battery is fully charged
before storing and charge every month thereafter.
Ensure your Lithium battery isolation switch is in the OFF (0) position during transportation.
Please refer to the product labels on your battery and charger for more information.
At the end of the battery’s life, dispose at your local recycling centre.
Charging Your Lithium Battery
SN:
All PowaKaddy electric trolleys
have been awarded the Quiet Mark
by the Noise Abatement Society
Accessory Bracket Fitting Instructions
7
6
The accessory bracket for your Compact C2 is supplied with your trolley in the
box. Attach the bracket to the two upper tubes as shown below. Orientate the
bracket to follow the curvature of the handle. Secure using the two screws and
nuts provided.
To Next Page
Loading...
Need help?
General
